Reassemble your Obelisk Slim


You took your miner apart, did what you needed to do, and now it's time to put it all back together.

Time Required

Less than 10 minutes

Things you'll need

A 1/8 inch (3.175 mm) hex wrench. You can use the one supplied with your Obelisk Slim.

An ESD (electrostatic discharge) safe surface.

Reassemble your Obelisk Slim

This section assumes you've already got your boards reinserted. If you haven't done this yet, you can learn how here.
  1. On the red fan grill you'll see a guide cutout on each side. Inside the black case you'll see two pegs for these cutouts. The guides rest on the pegs to ensure the fan grill is seated correctly inside the case.
  2. Place the rear fan grill back in the case. Make sure that the fan grill guide rests on the fan grill peg. You should be able to easily slide it into the following position once you line it up.
  3. Then push it fully back into place. You'll feel it click once it is fully upright.
  4. Now you need to connect the rear fan grill power cables. Take the two white connectors and gently reattach them to the control board, taking care not to bend the pins on the board.
  5. Place the top case back on the miner, making sure to line up up the hash board power connectors with the openings in the top case.
  6. Reinstall the top case screw using the supplied hex wrench.
  7. Reconnect the power cables and turn the unit on.

How did we do?

Powered by HelpDocs (opens in a new tab)